Cbs-scientific QNX-700 Manuel d'utilisateur télécharger pdf (Page 8)

Quadra Instructions 9-30-13

SECTION 3

Instructions for Slab Gel Electrophoresis Using Pre-Cast Gels

3.1 Preparing the Electrophoresis Unit

1. Power leads are shipped separately and

must be attached before using your

Quadra. Thread the power lead ends into

the lid receptacles and rotate in clockwise

direction to hand tighten.

2. Place unit in authorized work area. Remove

safety cover from the assembled unit by

simultaneously pressing down on white push

pins while lifting up on blue safety cover as

shown in gure 1.

Do not remove safety cover by pulling up

on leads!

3. Remove white core from lower reservoir

by grasping core with one hand and lifting

directly up as shown in gure 2. Remove

second core in same manner.

4. Open doors on the core assemblies by

pulling up on the white latches, as shown in

gure 3.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Cbs-scientific QNX-700 Manuel d'utilisateur Page 8