Cbs-scientific QNX-700 Manuel d'utilisateur télécharger pdf (Page 14)

Quadra Instructions 9-30-13

SECTION 4

Alternate Protocol for Slab Gel Electrophoresis.

(Not using Pre-cast gels)

4.2 Preparing the Electrophoresis Unit when Using Gel Wrap™ Gasket

Casting Method

1. Place unit in authorized work area. Remove safety

cover from the assembled unit by simultaneously

pressing down on white push pins while lifting up on

blue safety cover as shown in gure 1.

Do not remove safety cover by pulling up on leads!

2. Remove white core from lower reservoir by grasping

core with one hand and lifting directly up as shown in

gure 2. Remove second core in same manner.

3. Open doors on the core assemblies by pulling up on

the white latches, as shown in gure 3.

4. Slide glass plate sandwiches into the core assemblies

with the notched plate facing in towards the upper

buffer reservoir as shown in gure 4.

5. If running one gel, slide white plastic adaptor plate into

the side without the gel.

6. Close doors and relatch by pressing down on the

white latches so that the assembly looks like that

shown in gure 5.

9. For rest of protocol please refer to instructions on

pages 10-11 (Sections 3.2 and 3.3) for running the gel

and removing it after electrophoresis.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Pas de commentaire

Cbs-scientific QNX-700 Manuel d'utilisateur Page 14